Flight Controller F722-WPX
STM32F722, MPU6000, DPS310, Pixel OSD, SD Blackbox, 10x PWM outputs, 6x UARTs, I2C, Camera switch
Gallery
Spec.& Manual
F722-WPX Quick Start Guide (PDF 8M)
FC Specifications
- MCU: 216MHz STM32F722RET6
- IMU: MPU6000 (SPI)
- Baro: DPS310 (I2C)
- OSD: Pixel OSD/FrskyOSD (Uart6)
- Blackbox: MicroSD socket (SPI)
- 6x UARTs(5 Spare) with built-in inversion
- 1x Softserial_Tx option
- 10x PWM outputs
- 1x I2C
- 4x ADC (VBAT, Current, RSSI, AirSpeed)
- 1x SH1.0_6pin connector (4V5/G/TX4/RX4/SDA/SCL) for GPS/compass
- 1x SH1.0_6pin connector for external USB and buzzer
- Dual Camera Inputs switcher
- Vbat filtered power ON/OFF switcher
- PWM camera menu control: Not supported by INAV
- DJI FPV air unit: any spare UART
Power
- 6~30V DC IN (2~6S LiPo)
- 132A high-precision Current Sense (Scale 250)
- PDB/Current sense resistor: 60A continuous, 132A burst.
- BEC 5V 2A for FC & Peripherals
- BEC Vx 5A for servos, 5V/ 6V option
- Vbat filtered output 1A for VTx and Camera
- LDO 3.3V 200mA
- Battery Voltage Sensor: 1:10 (Scale 1100)
FC Firmware
- INAV target: MATEKF722WPX
Physical
- Dimensions: 44 x 29 x 10 mm
- Mounting: 25 x 25mm, Φ2mm
- Weight: 20g w/ bottom plate and USB/buzzer adapter
Including
- 1x FC F722-WPX
- 1x USB(Type-C)/Buzzer (Active) Adapter
- 1x Bottom plate, 44 x 29mm
- 2x JST-SH-6P to JST-SH-6P cables, 20cm
- 5x Brass standoffs, M2*4mm
- 10x screws, M2*3.5mm
- Dupont 2.54 pins (Board is shipped unsoldered)
Layout
Wiring & settings
Notes & Tips
- INAV2.5.x downloaded from configurator doesn’t support Barometer DPS310 and SD card.
- Pls use INAV2.6.x target MATEKF722WPX
——————————————————————–
FrskyOSD APP and fw 2.0.0
- https://github.com/FrSkyRC/PixelOSD/tree/master/firmware
- Update: The Github repository has been removed by Frsky. You might download the APP and fw from our website. FrSky_OSD-win64.zip
Resellers